A driveway of pavers that stays tight and clean
Driveway Paver Sealing in Murray Hill, FL
Request a free driveway paver sealing estimate for your Murray Hill home at (904) 479-9763.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can a local contractor seal my Murray Hill driveway pavers soon?
Driveway paver sealing is offered all over Murray Hill, FL, and a local contractor responds within 1 business day, usually much sooner. The visit and the quote are free, with no obligation. To get started, call (904) 479-9763.
Your driveway gets the most abuse of any paved area at the house. Tires scuff it, oil drips on it and the sun bakes it from morning to evening. Sealing locks the sand into the joints, protects the surface and brings back a clean color. If a front walk uses the same pavers, it can be priced on the same visit, so list every paved area you want covered. To describe yours, ask for a free estimate.
Where around Duval County can driveway sealing be scheduled?
Every place below has its own page, and each one is reachable by the same short request. Murray Hill homes are the focus here, but the list reaches across Northeast Florida. If your street is missing, call (904) 479-9763.
What do tires, oil and sprinklers do to driveway pavers?
Three things wear a driveway down faster than weather alone. Each has a fix, and most fixes happen before the sealer goes on. Mention whichever you see when you ask for a free estimate.
Tires and hot summer pavement
Summer highs hold near 91 degrees, based on NOAA normals, and Unilock warns that pavers that are too hot can stain or peel a new coat. Sealing is scheduled around the pavement temperature, not only the calendar. Heavy vehicles may also call for an earlier reseal. To plan around your cars, call (904) 479-9763.
Oil and gasoline drips
Unilock says a sealed driveway keeps oil and gasoline from soaking in. Old stains are another story, and a Northeast Florida washing company treats oil and tire marks with chemistry when water will not move them. Point out each dark spot when you ask for a free estimate.
Orange spots from sprinklers
UF/IFAS notes that irrigation water high in iron leaves stains and that most Florida well water is high in iron. The washing company says more pressure makes rust worse and that a rust treatment and a rinse come first. If a stripe follows your sprinkler heads, call (904) 479-9763.
Do smaller, older Murray Hill lots change how a driveway is sealed?
Wikipedia describes Murray Hill as a neighborhood of mostly smaller homes, in brick, wood, stucco and concrete, with the oldest house dating to 1898. On a lot that size the driveway sits close to fences, plants and the neighbor's yard. Overspray control matters, and Unilock suggests shielding edges with a flat sheet. For a look at your property line, ask for a free estimate.
Tight lots also mean tight parking. With sealing done in one session and up to 48 hours of dry weather afterward, the car has to live somewhere else for a day or two. Ask the contractor for a plan before the date is set. Call (904) 479-9763 to talk through it.
Which sealer holds up to a car every day?
Unilock says solvent based sealers suit high shine and high traffic and last four to five years if maintained. Water based sealers suit matte, lower traffic areas, have low odor and help harden the joint sand. Both run $80 to $150 a gallon, covering 80 to 120 square feet for solvent and 100 to 150 for water based. To hear which one goes on your driveway, call (904) 479-9763.
Solvent based coats need pavers and joints to be fully dry, which is a good reason to avoid sealing after a wet week. A water based coat is easier to clean up and gives a flatter look. Ask the contractor to name the product, and to ask for a free estimate.
What happens on the day your driveway is sealed?
A company that publishes the $1.75 to $3.25 range says a job takes about two days when joints are empty or the old sealer failed. A first seal on sound pavers can move faster. Here is the usual order of the process, so the days make sense. To book the days, call (904) 479-9763.
Day one, morning
Measure, test a patch, cover plants and wash the surface with a surface cleaner so there are no wand stripes.
Day one, afternoon
Treat oil and rust, then sweep in kiln dried sand and compact it. Sand graded to ASTM C144 is what one company uses.
Day two, early
Let everything dry. Damp sand is fine, but standing water is not, so the contractor checks before any sealer opens.
Day two, finish
Spray or roll the sealer in one session, roll out puddles, then keep cars and sprinklers off while it cures.
What does driveway paver sealing cost in Murray Hill?
No page prices driveway pavers on their own, so the table multiplies the published range of $1.75 to $3.25 per square foot to clean, sand and seal. One company lists sealing from $1.90 and cleaning from $0.22, with the price set by square footage, paver type and joint sand. For a number on your own driveway, ask for a free estimate.
| Driveway size | Area | Clean, sand and seal | Cleaning alone, from $0.22 |
|---|---|---|---|
| 12 by 20 feet, one car | 240 sq ft | $420 to $780 | $53 |
| 20 by 20 feet, two cars | 400 sq ft | $700 to $1,300 | $88 |
| 24 by 25 feet, wide two car | 600 sq ft | $1,050 to $1,950 | $132 |
| Driveway plus front walk | 900 sq ft | $1,575 to $2,925 | $198 |
Published ranges come from two Northeast Florida companies and are not a quote. Stripping failed sealer, leveling sunken pavers and repairs are priced separately.
A plain concrete driveway wash is a different job, and one washing company lists it at $150 to $400. Pavers need joint sand and sealer, which is where the larger numbers come from. To compare a bid, call (904) 479-9763.
Check the paver stain removal page for oil and rust, or the paver restoration page if the old coat has peeled.
Can sealing fix a sunken or ponding driveway?
No, and Unilock says so plainly: sealing is not a fix for poor drainage or subbase problems. A paver that rocks under a tire or a low spot that holds water needs repair before any coat helps. Sealing then tightens the upper layer of the sand joints, which makes weeds less likely to take root. To have a low spot looked at, ask for a free estimate.
Open joints during rainy months let water scour the bedding sand, according to a Northeast Florida washing company, and that can cause rocking and settling on sandy local soils. Refilling the joints early costs less than resetting pavers later. Call (904) 479-9763 if you see gaps.
What time of year suits driveway sealing in Murray Hill?
A washing company calls October and November a good window for sealing and says summer storms bring algae and wash sand from the joints. Unilock wants 50 to 90 degrees, with 75 the sweet spot, and 24 to 48 hours of clear skies on each side of the job. With roughly 53.4 inches of rain a year, a forecast check beats a calendar date. Ask about openings when you ask for a free estimate.
What do sealed driveways look like around Murray Hill?
Questions Murray Hill homeowners ask about driveway sealing
Is it good to seal pavers in Florida?
On a driveway, usually yes. Sun, afternoon storms and oil drips wear on bare pavers, and a sealed surface blocks much of that. Unilock calls sealing optional, since its pavers perform without it, so weigh the upkeep you would like to save.
How long do paver sealers last?
Unilock says solvent based sealers last four to five years when maintained, while heavy vehicle traffic may shorten that. Companies in Northeast Florida give two to five years. A driveway that carries two cars daily lands toward the lower end.
How much does it cost to have pavers cleaned and sealed?
At the published $1.75 to $3.25 per square foot for a full clean, sand and seal, a 400 square foot driveway comes to $700 to $1,300 and a 600 square foot one to $1,050 to $1,950. Failed sealer, empty joints and repairs are extra.
Why is paver sealing so expensive?
Most of the bill is prep and labor, not the sealer. Washing, stain treatment, new joint sand and a dry window all come before the coat. Unilock lists sealer at $80 to $150 a gallon, and a gallon covers roughly 80 to 150 square feet depending on type.
Can I drive on the driveway the day it is sealed?
No. Unilock tells owners to keep vehicles off during curing and asks for up to 48 hours of dry weather. Plan to park in the street or at a neighbor's for that stretch, and ask the contractor for the exact wait on the label.
Will sealing stop oil stains on my driveway?
It helps block them. Unilock says a sealed driveway keeps oil and gasoline from soaking in, and a washing company says fresh drips are treated with chemistry when water alone will not lift them. Old stains are treated before sealing, not buried.
Can I seal half of my driveway now and the rest later?
It is better to avoid that. Unilock advises sealing the whole area in one session so coats do not stack or leave an uneven line. If cars must move, the contractor can plan the order and the parking.
What causes orange spots along my driveway edge in Murray Hill?
Iron in the sprinkler water is behind most of them. UF/IFAS says water high in iron stains surfaces and that most Florida well water is high in iron. A washing company adds that more pressure makes rust worse and a rust treatment comes first.
Want a price on your driveway pavers?
Send the short form or call, and a local contractor gets back to you within 1 business day, usually much sooner.
Free, no obligation